家用电梯/别墅电梯 整梯功能表 Function list

实用功能名号
Function

功用叙说
Desprication

合集选
FCL-Full Collective Operation

在家装无机房电梯轿厢/大别墅无机房电梯轿厢自动状态或司机状态，电梯在运行过程中，在响应轿内指令信号的同时，自动响应上行、下行时的召唤，任何层楼的乘客，都可通过登记上下召唤信号召唤电梯。
In automatic or attendant service,the elevator responds to the command signal in the car while automatically responding to the call when going up and down.Passengers on any floor can call the elevator by registering the up and down call signals.

抢修启动
Inspection Running

这是在检修或调试挂式电动扶梯轿厢/別墅电动扶梯轿厢时使用的操作功能。当符合运行条件时，按上/下行按钮可使电梯以检修速度点动向上向下运行。持续按下按钮，电梯保持运行，松开按钮即停止运行。
Up/down running in inspection speed.The elevator keep running by push on the button and stop when loosen the buton.

会停站
Directly Parking

以距离为原则，自动运算生成从启动到停车的平滑曲线，没有爬行，生活费自动扶梯/房子自动扶梯直接停靠在平层位置。
With distance for the principle,automatic operation generated from start to stop a smooth curve,no creep,parked in the flat position directly.

自行应对平层电脑运行
Auto rescue running

当家居高层自动扶梯/别墅房高层自动扶梯处于非检修状态下，且未停在平层区，此时只要符合起动的安全要求，电梯将自动以慢速运行至近平层区，然后开门。
When the elevator is not in maintenance mode, and did not stap on the leveling area, when meeting the safety requirements, the elevator will automatically run at slow to a leveling area recently, and then open the door.

危应急援正常运作
Emergency rescue running

对于人力操作提升装有额定载重量的小型家用货梯/大别墅家用货梯轿厢所需力大于400N的电梯驱动主机，设置紧急电动运行开关及操作，以替代手动盘车装置。
When manual winding required over 400N, set up the emergency electric operation switch and operation, to replace manual winding.

发电机主要参数通过自学习
Motor parameter self learning

家廷用无机房电梯上/別墅无机房电梯上系统在运行前对电机参数进行自学习。
Self learning the motor parameters when the system is first running.

井道主要参数自学雅思习
Shaft parameters self learning

体系在专车电脑运行前，需用对井道的数据展开通过自学习，分为每一层的建筑面积、勉强缓速控制开关角度。
First normal running. the system need self learning about the shaft parameters, including each floor height. the position of deceleration switch.

会自动返基站天线
Automatic returm to main landing

当可超过快速设置时候，仍无内壁指今和层站招换时，家用电梯全自动刷新页面基站设备听候司乘人员。
When there is no order or calls, after a period of time the elevator will automatic return to the main landing.

熄灯节电实用功能
FLP-Fan and light protection

当超过设定时间，仍无内部指令和层站召唤时，则自动切断小型货梯/别墅房货梯轿厢内照明、风扇等电源。
Elevator will enter energy saving mode under no operation, turn off the car light and fan automatically within present time after door closing.

之前之后门的服务楼房设制
Front and back opening setting

小型高层住宅电梯/酒店高层住宅电梯系统可根据需要分别对前门和后门选择服务楼层。
The system can set the front or back opening according to requirement.

业务层软件设置
Service floor setting

系统可根据需要灵活选择关闭或激活某个或多个家居高层电动扶梯/独栋别墅高层电动扶梯服务楼层及停站楼层。
The system can set the service floor according to requirement.

系统自动改正轿厢职位
Automatic correct the position of cabin

家装客梯/小别墅客梯每次运行到端站位置，系统自动根据Diyi级强迫减速开关检查和修正轿厢的位置信息，同时辅助特制的强迫减速减速度彻底消除冲顶和蹲底故障。
Elevator run to the end station every time, the system will check and correct the position of cabin automatically according to the first forced deceleration switch, and auxiliary special forced deceleration to eliminate the fault of overrunning

起跳楼层显示信息
Floor display

比较灵活构成厅外界面显视抑制板界面显视项目，可能可根据须得将界面显视软件设置为非陆续的数据。
The flooro display can be discontinuous floor according to requirement.

反相半自动消号
Automatic elimination of reverse command

当家廷用自动扶梯/房子自动扶梯运行到终端层站或者运行方向变更时，将此前所登记的反向指令全部自动取消。
When the first or last landing is reached and elevator has to reverse, all commands originally registered will be eliminated.

按钮门告警保护区
Open and close fault protection

当测试到打开门高达设制危害后未曾管用倒闭，设备关闭程序打开门并内容输出错误码。
When open and close over setting times still not effective, the system will stop opening or closing and show faulty.

提高开馆时光的各类控制
Opening keep time setting separately

家里用的电梯安装安装/小洋房电梯安装安装系统根据设定的时间自动判别召唤开门、指令开门、门保护开门、延时开门等不同的保持开门时间。
The system will judge the opening keep time of calling opening, order opening, protection opening, delay opening through the setting time.

全线贯通门孤立调整Independent control of through opening

用洞通门时，可分別另外把控好先后门。
Independent control of front or back door when through opening

强迫性减慢速度探测的功能
Forced deceleration detection

家庭装电梯安装安装/别野电梯安装安装系统在自动运行模式下，根据强迫减速开关位置、以及开关动作情况来监测、校正电梯轿厢的位置。
Under auto running, the system will detect and correct the position of cabin according to the position of forced deceleration switch and the operation situation of switch.

营业开关按钮门区营业
Open button

家庭支出住宅电梯安装/大别墅住宅电梯安装停在门区时，可以在轿厢中按开门按钮使电梯已经关闭或尚未关闭的门重新打开。
When elevator stop in door zone, can reopen the door through open button in cabin.

本层厅外开业
Open in landing

在无别的指令英文或外召的环境下，若轿厢经停在某一些层站， 按着该层站内的招呼快捷后，轿厢门主动开放。
When there is no call or order, the cabin stop in one floo, push the call box in landing, the door will be automatically open.

再次倒闭
Re-closing

家庭用的客梯/别墅房客梯持续关门一定时间后，若门锁尚未闭合，则电梯自动开门，然后重复关门。
If the door lock not closed after the door keep closing for a period of time, the elevator will automatically open door, and re-closing.

满负荷直驶
LNS-Load non stop

在系统自动无货车司机正常运作环境，当轿内载满时(正常为額定负荷的80%) ,高层电梯不死机路过的厅外觉醒数据信号。
When car is loaded to a predetermined percentage pf its capacity(normally it's 80%), it is considered"full". The car will bypass further hall calls.

限载保护措施
LWS-overload protection

保证家庭装高层电梯安装/独栋别墅高层电梯安装轿厢运行时的速度在安全控制范围内，以保证乘客的安全。
If the load exceeds the rate load, the sound signal will be given out by speaker, and "OVERLOAD" will be displayed, the car door will not close,the elevator will not start.

防抱死保護
Anti-slip protection

在非检修状态，家廷用货梯/花园洋房货梯运行过程中，如果连续运行了F9-02规定的时间(45秒)后，而且没有平层开关动作过，系统就认为检测到钢丝绳打滑故障，所以就停止轿厢一切运行。
In the state of no maintenance, elevator running process, if the continuous operation over the stipulated time of the F9-02 (maximum 45 seconds)and there is no leveling switch action, the system think rope slipping fault is detected, so they stop all running of cabin.

接受器接触点监测护理Contactor detection protection

家居用电动扶梯/別墅电动扶梯在运行或者停止状态下，检测到接触器的吸合状态异常时，系统自动保护。
When elevator is running or stop, if the contactor is detected abnormal, the system will automatically protect.

电动机过电压守护
Motor over-current protection

检测到电机的电流大于Z大允许值时，生活费客梯/别墅装修客梯系统自动保护。
The system will auto protect if detected the motor current over the max. allowed data.

外接电源过流维护降维护
Motor over voltage protection

判断到电电流电压超过Z大合法值时，体统全自动守护。
The system will auto protect if detected the motor voltage over the max. allowed data.

同步电机过载保护措施保护措施
Motor over load protection

检测到家庭用的高层家庭电梯/房子高层家庭电梯电机过载，系统自动保护。
The system will auto protect if detected the motor overload.

识别码器出现问题保护性
Encoder faulty

全系统只使用一个高速编码器来进行闭环矢量控制，如果该编码器发生故障，家居无机房电梯安装/别野无机房电梯安装系统自动停机，避免因无法得知编码器故障引起的冲顶蹲底的故障。
Only one high-speed encoder for closed-loop vector control is used in system, if the encoder failure occurs, the system automatically shut down,prevent due to unknown encoder failure caused overrunning failure.

错误码长达纪要
Fault record

系统具有6个故障记录，包括家装住宅别墅家用电梯/别墅装修住宅别墅家用电梯故障产生的时间与楼层等信息。
The system will records 6 faults, including the time and floor information of the fault.

称准表现弥补
Weighing signal compensation

整体应该在高级广泛应用领域中的使用称量走势，对住宅电梯的开机完成补偿费。
System can use weighing signal in special application, to compensate the starting.

预力矩配置
Pre-torque setting

系统可预先输出与相应负载匹配的转矩，以保证家庭装升降机/小洋房升降机的舒适感。
System can be output in advance with the corresponding torque load matching, to ensure the comfort of the elevator.

防盗锁短接测量
Short detection of door lock

小型住宅电梯上/别墅房住宅电梯上在自动运行模式下，每次开门到位均识别门锁是否存在异常。
Under auto running, it will detect whether the door lock is abnormal during every door opening.

公测自动运行
Test running

各种測試加载属于新高层电梯的困乏各种測試加载、请勿外召为了响应、请勿触点开关按钮门、屏幕端站限位器触点开关按钮、屏幕超载超限预警等各种測試加载的办法。
Including fatigue test run of the new lift, prohibit called response, prohibit open close the door, blocking end station limit switch,shielding overload signal etc. test methods.

支持一键寻求帮助基本功能
One key for help

在控制箱上无法接通电话快捷，对配电柜可视对讲机主机系统箱通过拨叫，当无对答时，可视对讲机主机系统箱将自动式向分别安装好的3组通手机号号码查询(或手机号)通过拨打，甚至无法接通即可。
The communication button in COP will call the master phone in controller first, if no answer, it can dial to 3 setting numbers in turn, until it's connected.

停机紧急自然平层Emergency autorescue device

当由于楼房停电导致运行中的轿厢不在门区而困人时，停电应急平层装置就会启动，驱动家庭支出升降机/别墅楼盘升降机就近低速运行到门区开门放人。
when power off, the car is not in the leveling zone, the emergency auto rescue device will start, drive the car to the door zone and open to release he passengers.